DeWalt D25414 Manuel d'instructions

D25413-XE, D25414-XE, D25415-XE, D25430-XE32 mm (1-1/8") HEAVY DUTY ROTARY HAMMERINSTRUCTION MANUAL

8WARNING: Drill may stall if overloaded causing a sudden twist. Always expect the stall. Grip the drill firmly with both hands to control the twisting

9HAMMERDRILL OPERATION 1. When drilling, use just enough force on the hammer to keep it from bouncing excessively or “rising” off the bit. Too much f

Stanley Black & Decker82 Taryn Drive, Epping, VIC 3076 Australia • 1800 338 002 (Aust) or 0800 339 258 (NZ)www.dewalt.com.au • www.dewalt.co.nz(

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be us

3c) Prevent unintentional starting. Ensure the switch is in the off position before connecting to power source and/or battery pack, picking up or car

4WARNING: We recommend the use of a residual current device with a residual current rating of 30mA or less.WARNING: ALWAYS wear approved protective sa

5min ...minutes or AC ...alternating currentor DC ...direct current or AC/DC ...alternating or ...Class

6ADJUSTMENTSWARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments

7Quick Change SDS Chuck (Fig. 5)(D25414-XE & D25415-XE ONLY)The SDS chuck can be easily removed by turning the collar (L) into the unlocked positi