DeWalt DW997 Manuel de service télécharger pdf (Page 14)

--- 10 ---

10. REPAIR GUIDE

Be sure to remove the storage batteries from the main body before servicing. Inadvertent triggering of the switch

with the storage battery connected will result in a danger of accidental turning of the motor.

10-1. Precautions in Disassembly and Reassembly

The [Bold] numbers in the description below correspond to the item numbers in the Parts List and exploded

assembly diagram for the Model DV 18DV.

10-1-1. Disassembly

(1) Removal of the Drill Chuck 13VLRF-N (W/O Chuck Wrench) [2] (See Fig. 4.)

Remove the Drill Chuck 13VLRF-N (W/O Chuck Wrench) [2] of the fully assembled main body in accordance

with the following procedures.

(a) Fully open the jaws of the Drill Chuck 13VLRF-N (W/O Chuck Wrench) [2], and turn the Special Screw

(Left Hand) M6 x 23 [1] clockwise and remove it. Take care that it is left-hand threaded.

(b) Fix the hexagonal bar wrench M10 into the Drill Chuck 13VLRF-N (W/O Chuck Wrench) [2] as indicated in

Fig.4. Next, apply the Wrench 14 mm (special repair tool, Code No. 873929) [601] to the flat surfaces on

the spindle to hold it steady, and remove it by turning counterclockwise. If it is difficult to loosen, use a pipe

extension or similar tool.

(2) Removal of Housing (A). (B) Set [35]

First, align the drill mark " " on the Cap [4] with the triangle mark on Housing (A). (B) Set [35].

Remove the eight Tapping Screws (W/Flange) D3 x 16 (Black) [32] secured to the main body. Gently open

Housing (A). (B) Set [35] while holding their battery loading sections.

(3) After Housing (B) [35] has been removed, all the internal parts, assembled or separate, can be taken out as

they are. Lift the entire contents from Housing (A) [35] while holding the Motor [31] and the Cap [4].

Hexagonal bar wrench M10

Wrench 14 mm

Drill Chuck 13VLRF-N

(W/O Chuck Wrench) [2]

Flat surface

Fig. 4

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 26 27

Pas de commentaire

DeWalt DW997 Manuel de service Page 14