DeWalt DC300 Manuel d'instructions

DC300-XE36V CORDLESS CIRCULAR SAWINSTRUCTION MANUAL

8To install the battery pack into the tool handle, align the base of the tool with the rails inside the tool’s handle and slide the battery pack firml

9BladesWARNING: To minimize the risk of eye injury, always use eye protection. Carbide is a hard but brittle material. Foreign objects in the work pie

10removes sawdust from the cut, results in cooler, FIG. 8 faster sawing and reduces the chance of kickback. A method for checking for correct cut

11Figure 11 shows proper sawing position. Note that hands are kept away from cutting area. To avoid kickback, DO support board or panel NEAR the cut (

12 5. Make sure blade is not in contact with cutting surface before starting saw. 6. Start the motor and gradually lower the saw until its shoe res

13In addition to the warranty, DEWALT tools are covered by our:FREE ONE YEAR SERVICE CONTRACTDEWALT will also maintain the tool for free at any time d

14DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 • 20 Fletcher Road, Mooroolbark, VIC 3138 Australia(JUL06) Form No. 6

ACEBFGLJIHDC300 36 Volt Cordless Circular Saw 4000 RPM A. SWITCH LOCK-OFF BUTTON B. TRIGGER SWITCH C. BATTERY PACK D. DEPTH ADJUSTMENT LEVER

1IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US AT: 1800 654 155 (Aust) or 09 526 2556 (NZ). GENERAL SAFETY INSTRUCTIONS

2f. Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or

3 • Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth of the blade teeth should be visible below the workpiece. • Nev

4 ... direct current no ...no load speed ... Class I Construction ...earthing terminal ...

5 • An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the

6 • Charge the battery packs only in DEWALT chargers. • DO NOT splash or immerse in water or other liquids. • Do not store or use the tool and bat

7BAD BATTERYThe charger can detect a weak or damaged battery. The three red lights will flash together with rapid blinking. The battery will no longer