DeWalt D55371 Manuel d'instructions télécharger pdf (Page 9)







)

AUTO(–)/OFF(O) SWITCH

Place this switch (L) in the AUTO(–)

position to provide automatic power to the

pressure switch and OFF(O) to remove

power at the end of each use. NOTE:

ALWAYS ensure the switch (L) is in the

OFF(O) position before removing or

replacing pressure switch cover.

PRESSURE SWITCH

The pressure switch (H) automatically starts the motor when the

air tank pressure drops below the factory set cut-in pressure. It

stops the motor when the air tank pressure reaches the factory set

cut-out pressure.

SAFETY VALVE

If the pressure switch does not shut off the air

compressor at its cut-out pressure setting, the

safety valve (G) will protect against high pressure

by popping out at its factory set pressure (slightly

higher than the pressure switch cut-out setting).

CHECK VALVE

When the air compressor is operating, the check valve is open,

allowing compressed air to enter the air tank. When the air

compressor reaches cut-out pressure, the check valve closes,

allowing air pressure to remain inside the air tank.

TANK PRESSURE GAUGE

The tank pressure gauge (K) indi-

cates the reserve air pressure in

the tank.

REGULATED PRESSURE

GAUGE

The regulated pressure gauge (D)

indicates the air pressure available

at the outlet side of the regulator. This pressure is controlled by the

regulator and is always less than or equal to the tank pressure.

REGULATOR

The regulator (F) controls the air pressure shown on the regulated

pressure gauge. Pull the knob out and turn clockwise to increase

pressure and counterclockwise to decrease pressure. When the

desired pressure is reached push knob in to lock in place.

UNIVERSAL QUICK CONNECT BODIES

The universal quick connect body (E) accepts the three most popular

styles of quick connect plugs: Industrial, automotive, and ARO. One

hand push-to-connect operation makes connections simple and

easy. The two quick connect bodies allow the use of two tools at the

same time.

DRAIN VALVE

The drain valve (B) is located at the base of

the air tank and is used to drain

condensation at the end of each use.

See

Draining Air Tank under Maintenance.

COOLING SYSTEM

This compressor contains an advanced design cooling system.

It is normal for this fan to blow air through the vent holes in large

amounts. The cooling system is working when air is expelled.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Commentaires sur ces manuels

Pas de commentaire

DeWalt D55371 Manuel d'instructions Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Compresseurs d'air DeWalt D55371