DeWalt DW9116 Manuel de l'opérateur télécharger pdf (Page 8)

5.0 OPERATING INSTRUCTIONS

OPERATING PRECAUTIONS: The operator should always stand at least 20 feet behind the X-ray unit

and clear all personnel at least 20 feet behind the unit or at least 100 ft. from the front of the unit before

pulsing. The exclusion zone (below) should be a controlled area free of all personnel while X-ray pulses.

Figure 4: Exclusion Zone

PULSE SELECTION

1. Attach a charged battery and turn on the X-ray generator.

2. Press the RANGE BUTTON. The one’s digit of the LCD will blink twice and then go

blank.

3. Press the UNITS BUTTON to adjust the ones digit from 0 to 9.

4. Press the RANGE BUTTON again and the tens digit of the LCD will blink twice and go blank.

5. Press the UNITS BUTTON to change the tens digit from 0 to 9.

6. Press the RANGE or UNITS BUTTON again to accept the new pulse setting.

7. Both tens digit and units digit will blink to indicate acceptance of the new pulse setting. (If

RANGE or UNITS BUTTON is not selected after entering the pulse count the generator will

automatically accept the entered pulse setting after six seconds).

8. Press the UNITS BUTTON and EMERGENCY STOP BUTTON simultaneously to lock in pulse

setting. XRS-4 will retain locked in pulse setting until it is changed.

Select ones digit Enter ones value(0-9) Enter tens value (0-9) Change pulse default

(optional)

20’

100’

20’

X-ray Beam

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

DeWalt DW9116 Manuel de l'opérateur Page 8