DCF885-XE18 V CORDLESS 6.35 mm (1/4") IMPACT DRIVERINSTRUCTION MANUAL
8Installing and Removing the Battery Pack (Fig. 3)NOTE: For best results, make sure your battery pack is fully charged. FEFIG. 3To install the batter
9and depress the forward/reverse control button on the right side of the tool. To select reverse, release the trigger switch and depress the forward/r
10MAINTENANCEWARNING: To reduce the risk of serious personal injury, place the forward/reverse button in the lock-off position or turn tool off and di
Stanley Black & Decker701 East Joppa Road, Baltimore, MD 21286 • 82 Taryn Drive, Epping, VIC 3076 Australia (MAR11) Part No. N106288 DCF
1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to
2c) Prevent unintentional starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch
3 • Replacement of the supply cord. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised DEWALT Service Centre in
4 • Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 40˚C (105°F) (such as outside sheds or meta
5 • Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.WARNING: Burn
6 3. The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully charged and may be used at this time or
7 a. Check operation of receptacle by plugging in a lamp or other appliance; b. Check to see if receptacle is connected to a light switch whic
Commentaires sur ces manuels