DCD960-XE, DCD980-XE HEAVY-DUTY 13 mm (1/2") CORDLESS DRILL/DRIVER DCD950-XE, DCD970-XE, DCD990-XE HEAVY-DUTY 13 mm (1/2") CORDLESS HAMMERDR
8 2. The charger and battery pack may become warm to touch while charging. This is a normal condition, and does not indicate a problem. To facilitate
9NOTE: Side handle comes equipped on models DCD950-XE, DCD960-XE and DCD970-XE.Forward/Reverse Control Button (Fig. 2)A forward/reverse control button
10NOTE: The torque adjustment collar (E) may be set on any number. SCREWDRIVING (FIG. 4)Rotate the mode control collar (F) so the screw symbol is alig
11 3. Insert the accessory about 19 mm (3/4") into the chuck and tighten securely by rotating the chuck sleeve clockwise with one hand while hol
12To remove the battery pack from the tool, press the release buttons (J) and firmly pull the battery pack out of the tool handle. Insert it into the
13RepairsThis charger is not user serviceable. There are no user serviceable parts inside the charger. Servicing at an authorized service center is re
DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 • 20 Fletcher Road, Mooroolbark, VIC 3138 Australia(DEC08) Part No. N02
1IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US AT: 1800 654 155 (Aust) or 0800 339258 (NZ). SAFETY INSTRUCTIONS FOR POW
2c) Prevent unintentional starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch
3 • Young children and the infirm. This appliance is not intended for use by young children or infirm persons without supervision. Young children shou
4Residual Risks • In spite of the application of the relevant safety regulations and the implementation of safety devices, certain residual risks ca
5received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Electric shock or ele
6CAUTION: Burn hazard. To reduce the risk of injury, charge only DEWALT rechargeable batteries. Other types of batteries may burst causing personal in
7Chargers Your tool uses a DEWALT 12, 14.4, 18 Volt charger. Be sure to read all safety instructions before using your charger. Consult the chart at t
Commentaires sur ces manuels