DeWalt D2002M Manuel d'instructions télécharger pdf (Page 11)

English

numberdecreases.12AWGand10AWGmayalsobeused.

DONOTUSE16OR18AWG.)

NOTICE: Risk of Property Damage. The use of an undersized exten-

sion cord will cause voltage to drop resulting in power loss to the

motor and overheating. Instead of using an extension cord, increase

the working reach of the air hose by attaching another length of hose

to its end. Attach additional lengths of hose as needed.

Voltage and Circuit Protection

Refer to the Voltage and Minimum Branch Circuit Requirements under

Pump/Motor Specifications.

CAUTION: Risk of Overheating. Certain air compressors can be

operated on a 15 amp circuit if the following conditions are met.

• VoltagesupplytocircuitmustcomplywiththeNationalElectrical

Code.

• Circuitisnotusedtosupplyanyotherelectricalneeds.

• Extensioncordscomplywithspecifications.

• Circuit is equipped with a 15 amp circuit breaker or 15 amp

time delay fuse. NOTE: If compressor is connected to a circuit

protected by fuses, use only time delay fuses. Time delay fuses

should be marked “D” in Canada and “T” in the US.

If any of the above conditions cannot be met, or if operation of the

compressor repeatedly causes interruption of the power, it may be

necessary to operate it from a 20 amp circuit. It is not necessary

to change the cord set.

Compatibility

Air tools and accessories that are run off the compressor must be

compatible with petroleum-based products. If you suspect that a

material is not compatible with petroleum products, an air line filter

for removal of moisture and oil vapor in compressed air is required.

NOTE: Always use an air line filter to remove moisture and oil vapor

when spraying paint.

Location

Place the air compressor in a clean, dry and well ventilated area

at least 12" (30.5 cm) away from the wall or other obstructions that

willinterfere withthe flowof air. Keepthe compressoraway from

areas that have dirt and/or volatile fumes in the atmosphere. These

impurities may clog the intake filter and valves, causing inefficient

operation.

The air compressor pump and shroud are designed to allow for

proper cooling. The ventilation openings on the compressor are

necessary to maintain proper operating temperature. Do not place

rags or other containers on or near these openings.

Place the air compressor on a flat surface resting on the rubber

feet.

NOISE CONSIDERATIONS

Consult local officials for information regarding acceptable noise

levels in your area. To reduce excessive noise, use vibration mounts

or silencers, relocate the unit or construct total enclosures or baffle

walls. Contact a D

WALTservicecenter.

ELECTRICAL

Refer to all safety instructions before using unit. Observe extension

cord safety instructions if necessary. Always move the On/Off

switch (A) to the OFF position before removing the plug from the

outlet.

TRANSPORTING

Whentransportingthecompressorinavehicle,trailer,etc.,ensure

that the tank is drained and the unit is secured. Use care when

driving to avoid tipping the unit over in the vehicle. Damage can

occur to the compressor or surrounding items if the compressor is

tipped.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 54 55

Commentaires sur ces manuels

Pas de commentaire

DeWalt D2002M Manuel d'instructions Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Compresseurs d'air DeWalt D2002M