DeWalt 780 Manuel d'instructions

DWS780-XE 305 mm (12") DOUBLE BEVEL SLIDING COMPOUND MITER SAWINSTRUCTION MANUAL

88 • Do not attempt to cut excessively small pieces. • Allow the blade to cut freely. Do not force. • Allow the motor to reach full speed before

99 3. When the saw comes up to speed, lower the arm smoothly and slowly to cut through the wood. Let the blade come to a full stop before raising arm

1010Cutting Crown Moulding (fig. 1, 24A, 24B)Your mitre saw is well suited to the task of cutting crown moulding. In order to fit properly, crown moul

1111Alternative Method for Cutting Crown Moulding Cutting crown moulding using this method does not require a bevel cut. Minute changes in the mitre a

1212WARNING: Ensure the saw is mounted firmly to a stable flat surface. Failure to do so could cause the saw to be unstable and fall causing personal

13101010202020303030404040505050606060707070808080TABLE 1: COMPOUND MITER CUT (POSITION WOOD WITH BROAD FLAT SIDE ON THE TABLE AND THE NARROW EDGE AGA

Stanley Black & Decker701 East Joppa Road, Baltimore, MD 21286 • 82 Taryn Drive, Epping, VIC 3076 Australia 1800 444 224 (Aust) or 0800 339 258

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

22 • STABILITY. Make sure the miter saw is placed on a secure supporting surface and does not slip or move during use. If the mobility kit is install

3Electrical ConnectionThe electric motor has been designed for one voltage only. Always check that the power supply corresponds to the voltage on the

4Optional Accessories (fig. 2–8)The following accessories, designed for your saw, may be helpful. In some cases, other locally obtained work supports,

5ANGLE MAXIMUM CAPACITY OF CUT RESULT0° miterHeight 112 mm (4.4") Width 231 mm (9.1")Width 349 mm (13.75") Height 76 mm (3.0")45°

66NOTE: When using blades with a 5/8" (15.88 mm) diameter blade hole, the blade adapter will not be used and should be stored in a safe place for

7not indicate exactly 22.5°, turn the crown adjustment screw contacting the pawl with a 10 mm (7/16") wrench until the bevel pointer indicates ex